To call the graphic you have downloaded send the following commands  

FS + p + chr(i) + chr(0 ή 1 ή 2 ή 3) (δηλαδή Chr(28) & Chr(112) & Chr(i) & Chr(0 ή 1 ή 2 ή 3) 0,1,2,3 is the type of printing see below),

where i = graphic number downloaded from the printer thermal driver.

he command to center the Logo on the printer is

so the commands must be

Decimal 27 97 49 (Centering)

Decimal 28 112 1 48 (Printing Logo)

Decimal 27 97 48 (Alignment Left)

Για την ενεργοποίηση του μαχαιριού θα χρειαστεί να προστεθεί στην φόρμα εκτύπωσης ο χαρακτήρας ESC i τον οποίο μπορεί να βρείτε στο παρακάτω file

1st Way

Enable Beep Use from Printer Commands on the printer.

2st Way

he ASCII character ‘30’ (record separator) must be added to the form at the end as in file

Drawer can be activated

1. From Driver

With Command